Call Control Framework Example Configuration

The following example shows a Call Control Framework (CCF) configuration for NEs deployed in a single sub-domain in a single Kubernetes cluster.

You can specify general CCF configuration in the resource_create_config.info file, or you can provide a separate configuration file for CCF and Network Enablers (NEs), for example, you could provide CCF configuration in a file named ccf_create_config.info. MATRIXX Support recommends that you use a separate configuration file for CCF general configuration.

The minimum configuration must include the external M3UA SIGTRAN links to external STPs and the NE point codes for all potential NEs. You can take any future expansion into account by defining more of these than are required.

In this example, sub-domain routing is not required.

# TRA sub-domain routing configuration
Do you want to use a Traffic Routing Agent (TRA) for sub-domain routing (y/n)?n
 
# NEs will create cross-links with other NEs in the same access group if turned on here:
Do you want to configure cross-links between Network Enablers (y/n)?n 
Engine 1:Cluster 1:LogicalBlade 1:What are the M3UA IP addresses?proc-m3ua-s1e1-0.matrixx.svc.cluster.local
Engine 1:Cluster 1:LogicalBlade 2:What are the M3UA IP addresses?proc-m3ua-s1e1-1.matrixx.svc.cluster.local
 
#number of links, depends on number of NE pods in deployment,
Network Enabler:How many links do you want?1
Network Enabler defaults:Do you want to prompt for advanced link configuration (y/n)?
Network Enabler defaults:What is the transport protocol?SCTP
# SCTP port
Network Enabler defaults:What is the local port?2905
#port of sigtran tool
Network Enabler defaults:What is the remote port?
Network Enabler defaults: What is the link initiation?connect
Network Enabler defaults:What is the SIGTRAN network role?ASP
Network Enabler defaults:What is the SIGTRAN traffic-mode to use?loadshare
Network Enabler defaults:Do you want the M3UA link state to be actively managed (y/n)?n
Network Enabler defaults:Do you want to prompt for advanced route configuration (y/n)?
Network Enabler defaults:What is the priority of this route?0
Network Enabler defaults:What is the routing-context?-1
Network Enabler defaults:What is the M3UA network-indicator?2
Network Enabler defaults:What is the maximum SCCP segment size?0
# if number of links are more than 1 then following questions must be repeated to match number of links with postfix Link 1,2,..n. 
# External Link nameNetwork Enabler Link 1:What is the link name?CCF1_1_STP1_1
Network Enabler Link 1: Do you want to prompt for advanced link configuration (y/n)?n
# IP address of the sigtran tool(host machine) in case of testing
Network Enabler Link 1:What is the remote address?192.168.160.154
Network Enabler Link 1: What is the remote port?5001
Network Enabler Link 1:What is the ASP identifier?
Network Enabler Link 1: Do you want to prompt for advanced route configuration (y/n)?n
Network Enabler Link 1:What is the destination point-code?401
Network Enabler Link 1:Do you want SCCP SCMG messages sent on this route (y/n)?y